Provides a more upright, comfortable riding position by raising the original 7/8" (22mm) or 1-1/8" (28mm) diameter tubular handlebar by 30mm (1.2"). No need to replace your handlebars - simply remove the original top clamp, place the riser between the handlebar and original bottom clamp, and reinstall top clamp using included hardware.For use with original top clamp. No change of control cables, wiring, or hoses is required for most motorcycles however, the installer should always checking for adequate cable/wiring/hose slack during installation.
Available in silver (s). Sold as a pair.
Fits all bikes with OEM KTM telescopic fork bridge parts as shown in the fiche diagram on this page:
39 - 590.01.039.000 handlebar support for 22mm bar, OR
4383021-001 handlebar support for 28mm bar
38 - 590.01.038.000 handlebar top clamp for 22mm bar, OR
4383019-001 handlebar top clamp for 28mm bar
34 - 584.01.034.218 fork bridge
Kit consists of two 28mm H x 25mm OD x 10mm ID spacers and two M10 x 100mm hexagon socket screws.
For KTM bikes that use an OEM handlebar holder set from MAGURA. If the bottom part of the handlebar holder set is attached by two screws to the fork, then you can use the LEH.00.039.106 handlebar riser.
Check photo of bottom clamp on this page to be sure this bar riser kit will fit.
Works on same bikes as LEH.00.039.105.
*Note: 2005 650 Adventure has 18mm bar risers from the factory. Use of this kit on this model year will result in only a 10mm net increase over the original bar height.
Please follow all Torque Specifications to the letter Failure to do this will void warranty.