CART
Cart - $0.00

You have no items in your shopping cart.

CAD
YouTube Facebook Twitter 888-524-7921 Email Us

Givi Security Key Lock Replacement 3 Lock & Key Set for Trekker Outback, E55 Maxia 3, Trekker 33, 46, & 52, V35, V47, & V46 Cases

Givi Security Key Lock Replacement 3 Lock & Key Set for Trekker Outback, E55 Maxia 3, Trekker 33, 46, & 52, V35, V47, & V46 Cases

$62.99
SKU: Givi SL103

Out of stock, more on the way! Order now for fastest delivery.

Email me when back in stock

 

Email Me When Back In Stock

Enter your email below and we'll notify you when it is back in stock.


OR
 

Replace the locks on your Givi Case with the Givi Replacement 3 Lock & Key Set.

Replacement lock set for three cases. Keyed alike. Includes keys, and lock components.

Compatible only with the following Givi Cases

  • Trekker Outback
  • E55 Maxia 3
  • Trekker 33
  • Trekker 46
  • Trekker 52
  • V35
  • V47
  • V46

Note: If replacing red style Givi key lock, Givi Z640R Latch Plate is required for each.

Customer Reviews
Review by PhatS1
Rating
I have 3 trekker cases, bought at different times so each had its own key. This set included 3 lock sets all keyed alike, with 6 keys total. I would have given 5 stars but for the lack of directions, and I could not find anything on the web except " it's easy" and "make a diagram of yous before you dismantle". Well it was relatively easy, but no one mentioned the ball bearing that would come flying out! So, here are the steps to follow:
1 - open the case and look on the inside behind the lock mechanism. You will find two Phillips head screws. Remove them and retain for reuse.
2 - on the outside, pull the whole latch mechanism down and out.
3 - put the key in the lock. (BTW when examining your new locksets, do not remove the key unless the tumbler mechanism is in its sleeve. If you do, a piece will fall out of the tumbler and you might lose it)
4 - note how the plastic piece on the end of the old tumble is situated. Take a pic or draw it
5 - TRICKY PART, when you remove the nut and plastic piece as next described, there is a spring loaded ball bearing that will pop out. Look closely and you will see it below the plastic piece. Just go slowly.
6 - use a 10 mm wrench to remove the nut and washer on the end of the old tumbler
6 - pull straight out on the plastic piece, take it off and pull out the old tumbler
7 - assembly is the reverse, the only kinda hard part is keeping the ball in place when you install the plastic piece and the washer and nut. (Posted on 2015-02-03)
Write Your Own Review

Only registered users can write reviews. Please, log in or register